品牌：日本ALTECO 安特固
型号：ALTECO AY-5218C
三星认证、指定型号，设计产品三星手机、摄像头模组及所有含有BGA芯片的产品
Material Safety Data Sheet
Revision Number: 2011-023
Issue date: 10/5/2011
SECTION 1. CHEMICAL PRODUCT AND COMPANY IDENTIFICATION
Product Information
Product Name ： AY-5218C
Features Kinds ： Epoxy mixture Usage ： Epoxy Adhesive
Manufacturer Name ： ALTECO INC .
Address ：1-18-2, Hakusan, Midori-ku Yokohama, Kanagawa 226-0006 Japan
Section Concerned : Technical Dep. Person in charge : T.KANEKO
Phone :+81-45-932-1540 Fax :+81-45-939-5677
Date of Prep. : 10/5/2011
SECTION 2. COMPOSITION/INFORMATION ON INGREDIENTS
Name | CAS No. | Content (%) | Note. |
Epoxy resin (Bisphenol F type) | 30～50 | ||
Epoxy resin (Bisphenol A type) | 10～30 | ||
Acryl resin | 10～30 | ||
Mercaptan | 20～40 | ||
Amine adduct | 1～10 | ||
Others | < 1 |
This product is not considered hazardous as defined by 29 CFR 1910.1200
(OSHA Hazard Communication Standard)
SECTION 3. HAZARDS IDENTIFICATION
Emergency Overview ：Black Liquid , with epoxy odor .Low hazard for usual industrial or commercial handling.
Effects of overexposure ：Possible skin and eye irritation on contact.
inhalation of vapors in an unventilated area may induce headaches.
Exposure Limits ：
Ingredient ACGIH OSHA
(TWA) (PEL)
None
Carcinogen | |||
Ingredient | NTP | IARC | OSHA |
Epoxy resin (Bisphenol F type) | NO | NO | NO |
Epoxy resin (Bisphenol A type) | NO | NO | NO |
Acryl resin | NO | NO | NO |
Mercaptan | NO | NO | NO |
Amine adduct | NO | NO | NO |
Others | NO | NO | NO |
SECTION 4. FIRST AID MEASURES
Eyes Contact ：Immediately flush eyes with plenty of water for at least 15 minutes.
Get medical attention.
Skin Contact ：In case of skin contact, wash thoroughly with soap and water.
Do not use organic solvents for cleanup as they may dry or irritate the skin and act as a carrier
for chemical absorption.
Inhalation ：Remove affected person to fresh air.
Ingestion ：Low toxicity, get medical attention
SECTION 5. FIRE FIGHTING MEASURES
Flash point ： NA
Explosive limits ：N.A
Auto ignition temperature ：>460℃
Extinguishing Agents ：Carbon dioxide, foam, dry chemical
Hazardous products of combustion ：Toxic fumes (oxides of carbon & nitrogen) may be
evolved upon exposure to heat or open flame.
SECTION 6. ACCIDENTAL RELEASE MEASURES
Steps to be taken in case material is released or spilled ： Avoid breathing vapors.
Notify appropriate authorities if necessary. Absorb spill with inner materials (e.g. dry, sand, earth) then place in a chemical waste containers. Before attempting cleaning, refer to hazard caution information in other of the MSDS form.
Wear proper protective equipments (mask, apron and goggles).
.
SECTION 7. HANDLING AND STORAGE
Handling ： Keep closure tight and container upright to prevent leakage.
Avoid skin and eye contact. Wash thoroughly after handling.
Do not handle until all safety precautions have been read and understood.
Empty containers should not be re-used. Use with adequate ventilation.
Avoid prolonged or repeated breathing of vapor.
Storage ： Avoid contamination with incompatible materials.
Protect from direct sunlight.
Store in a cool (>5-℃), dry ,well ventilated location.
SECTION 8. EXPOSURE CONTROL/PERSONAL PROTECTION
Engineering Controls ：Provide adequate general ventilation where this product is used.
Skin Protection ：Use polyethylene or rubber gloves to prevent skin contact.
Eye Protection ：Use safety eyewear including safety glasses with side shields and
chemical goggles where splashing may occur.
Hygienic Practices ：Wash hands before eating, smoking, or using toilet facility.
Do not smoke in any chemical handling or storage area. Food or
beverage should not be consumed anywhere this product is handled or stored. Wash thoroughly after handling.
Personal Protection
Respiratory ：Positive fresh air exhaust should be provided in the work area,
respiratory equipment is unnecessary in normal use.
Skin ：Avoid skin contact. Wear gloves and impervious protective clothing if
frequent direct contact is likely.
Eyes ：Chemical safety goggles are recommended.
SECTION 9. PHYSICAL AND CHEMICAL PROPERTIES
Appearance: Black Odor: Amine
Physical state: Liquid PH: N.D.
Vapor pressure: N.D Vapor density: Heavier than air
Boiling point: >200℃ Freeze/melting point: ＜-10℃
Solubility in water: Insoluble Evaporation rate: Slower than ether.
Specific gravity 1.2
SECTION 10. STABILITY AND REACTIVITY
Conditions to avoid High temperature,
Hazardous Decomp. None
Incompatibility Oxidizer, amine, strong Lewis or mineral acid, thiosulfates..
Hazardous polymerization May occur. Smoke and toxic fumes may be evolved as a result
of uncontrolled exothermic reaction of large masses of material reacting with curing agents, such as peroxide, amines,
and exposure to light.
SECTION 11. TOXICOLOGICAL INFORMATION
Toxicity Oral LD50：＞11,400mg/Kg（Rat）.
Dermal LD50：N.D .
Severe eye irritant.
Moderate skin irritant..
Possible inhalation irritant.
May cause kidney or live damage.
Signs and Symptoms
of Exposure:
Irritation of eyes, skin, nose or throat. May cause severe dermatitis on
prolonged contact in sensitive individuals.
SECTION 12. ECOLOGICAL INFORMATION
Environmental Fate and Distribution:
This product is essentially insoluble in water.
Treat using the best available techniques to avoid
Environmental contamination.
SECTION 13. DISPOSAL CONSIDERTIONS
Disposal should be done in accordance with Federal, state and local environmental
control regulations. If waste is determined to be hazardous, use licensed hazardous waste
transporter and disposal facility.
Not a RCRA Hazardous Waste Material.
SECTION 14. TRANSPORT INFORMATION
DOT proper shipping name ：Not regulated.
DOT Hazard Class ： None.
DOT UN/NA Number ： None
SECTION 15. REGULSTORY INFORMATION
U.S. Federal Regulations ：
OHSA ：Non hazardous by definition of hazard communication standard
(40CFR372)
SARA Listed Ingredients
TSCA ：The chemical substances in this product are on TSCA Section 8
inventory.
Canadian WHMIS ：This MSDS has been prepared in compliance with Controlled Product
Regulations except for use of the 16 headings.
SECTION 16. OTHER INFORMATION
Abbreviations ：
ACGIH : American Conference of Governmental Industrial Hygienists
OSHA : Occupational Safety and Health Administration
TLV : Threshold Limited Value
PEL : Permissible Exposure Limit
NTP National Testing Program
IARC: International Agency for Research on Cancer
TSCA : Toxic Substances Control ACT
N.A. : Not Applicable
N.D. : Not Determined
